(((((HOW TO SWAP A c-4 TRANSMISSION)))))

[kats]

O.K. Most of you know this!
How do you adapt a c-4 transmission to a v6 4.0 that use to be stick?

[roach]

i'm sure someone will know better, BUT, i think you will need......

the bellhousing from a old pinto that had a C-4 and a V6 in it
the starter from the same vehicle
the flexplate from the same vehicle
tourq converter
then the obvious..... shifter, drive shaft, tranny cooler, tranny mount, etc etc etc....

[UndercoverFab]

the bellhousing from an early to mid 80`s bronco II will work to. I forget the specific years, sorry.

[AaronDixon]

It also depends on whether you have a 6-bolt or 8-bolt crankshaft. The 6-bolt is easy, the 8 bolt is custom. I think they changed over somewhere around 2000.

I hear early ranger c-3/c-5 bellhousings for the 2.8 v-6 fit.

Aaron